ps2004 发表于 2007-3-28 08:45

求高手帮忙DELL D600电池6Y270的问题bq8011(已解决。有图)

原先也用不了多久,最近以来插交流时闪桔色灯.拔掉AC后可以用几分钟.
刚买了一个新的Type C1295 rating 11.1V 4700mAh 53WH
现在想办法修复老的,有一些问题:
做了一个PHILIPS I2C ADAPTOR, 用SBW3.3读电池很多参数为5911.
(用SBW3.3读新电池也是很多参数为5911.)
读EEPROM(按24C04)得到的BIN文件每次都有几个(20~50)BYTE不同.
感觉SBW不支持BQ8011.新电池的文件不敢用.(V,A,W都不同). 求高手帮忙
该电池有无软件可以破解?

detail infor:
6Y270 14.8V 2200mAh 32WH
internal ic p/n: top: bq29310PW/bq8011DBT
bottom soic-8:S24C0/TBD35/1188 (PIN1234 SHORT) tssop8:CEA/351

[ 本帖最后由 ps2004 于 2007-3-30 10:52 编辑 ]

ps2004 发表于 2007-3-29 00:53

acplus12.exe破戒版报告

Smart Battery data
displayed by AccPlus 1.3
3/27/2007 4:15:03 PM


Manufacturer Access    1717 hex
Remaining Capacity Alarm    5911 mAh or 10mWh
Remaining Time Alarm    5911 minutes
At Rate    5911 mA or 10mW
At Rate Time To Full    5911 minutes
At Rate Time To Empty    5911 minutes
At Rate OK    True boolean
Temperature    5911 0.1 癒
Voltage    5911 mV
Current    5911 mA
Average Current    5911 mA
Max Error    5911 %
Relative State Of Charge    5911 %
Absolute State Of Charge    5911 %
Remaining Capacity    5911 mAh or 10mWh
Full Charge Capacity    5911 mAh or 10mWh
Run Time To Empty    5911 minutes
Average Time To Empty    5911 minutes
Average Time To Full    5911 minutes
Charging Current    5911 mA
Charging Voltage    5911 mV
Cycle Count    5911 count
Design Capacity    5911 mAh or 10mWh
Design Voltage    5911 mV
Specification Info    1717 hex
Manufacturer Date    8/23/1991 mm/dd/yyyy
Serial Number    5911 number
Manufacturer Name     string
Device Name     string
Device Chemistry     string
Manufacturer Data    17171717171717 hex
OptionalMfgFunction5    1717 hex
OptionalMfgFunction4    1717 hex
OptionalMfgFunction3    1717 hex
OptionalMfgFunction2    1717 hex
OptionalMfgFunction1    1717 hex

Specification Info   
Revision    Reserved
Version    1.0
VScale    -
IPScale    Multiplies by 10
   
Battery Mode   
Internal Controller    Supported
Battery Support    Primary or secondary
Condition    Battery OK
Controller    Enabled
Battery Role    Primary
Alarm Mode    Enabled
Charger Mode    Enabled
Capacity Mode    mA or mAh

Battery Status   
Over Charged Alarm    Charging no longer detected
Terminate Charge Alarm    Charging no longer detected
Over Temperature Alarm    Temperature is above limit
Terminate Discharge Alarm    Discharge no longer detected
Remaining Capacity Alarm    Capacity is less than alarm
Remaining Time Alarm    Time is less than alarm
Initialized    Calibration lost
Discharging    Accepting a charge current
Fully Charged    Battery is not in a full state
Fully Discharged    Relative state of charge >20%
Error Code    Unknown

ps2004 发表于 2007-3-29 00:54

C:\Program Files\SBWorkshop 3.71 demo会报告

Smart Battery Data Report.
Generated by Smart Battery Workshop
3/27/2007 11:43:48 AM

==========BatteryData==========
ManufacturerAccess: 1717hex
RemainingCapacityAlarm*: 5911mAh or 10mWh
RemainingTimeAlarm*: 5911minutes
AtRate: 5911mA or 10mW
AtRateTimeToFull: 5911minutes
AtRateTimeToEmpty*: 5911minutes
AtRateOK*: 5911Boolean
Temperature: 31790.1°C
Voltage: 5911mV
Current: 5911mA
OverageCurrent: 5911mA
MaxError: 5911percent
RelativeStateOfCharge: 5911percent
AbsoluteStateOfCharge: 5911percent
RemainingCapacity: 5911mAh or 10mWh
FullChargeCapacity: 5911mAh or 10mWh
RunTimeToEmpty*: 5911minutes
AverageTimeToEmpty*: 5911minutes
AverageTimeToFull: 5911minutes
ChargingCurrent: 5911mA
ChargingVoltage: 5911mV
CycleCount: 5911count
DesignCapacity: 5911mAh or 10mWh
DesignVoltage: 5911mV
ManufactureDate: 1991.8.23y.m.d.
SerialNumber: 5911number
ManufacturerName: 
DeviceName: 
DeviceChemistry: 
ManufacturerData: 1717171717171717177FFFFFFFFFFFFFhex
OptionalMfgFunction5: 17171717171717171717171717171717hex
OptionalMfgFunction4: 17170000000000000000000000000000hex
OptionalMfgFunction3: 17170000000000000000000000000000hex
OptionalMfgFunction2: 17170000000000000000000000000000hex
OptionalMfgFunction1: 17170000000000000000000000000000hex
==========BatteryMode==========
Internal Charge Controller Supported
Primary or Secondary Battery Function Supported
Battery OK
Internal Charge Control Enabled
Battery operating in its primary role
AlarmWarning broadcasts to Host and Smart Battery Charger Enabled
ChargingVoltage and ChargingCurrent broadcasts to Smart Battery Charger Enabled
Report in mA or mAh
==========BatteryStatus==========
OverTemp Alarm
Remaining Capacity Alarm
Remainig Time Alarm
Fully Discharged
==========SpecificationInfo==========
Revision 1.0 and 1.1
Version 1.0
VScale N/A
IPScale N/A
==========End==========

ps2004 发表于 2007-3-29 00:57

24c04.bin问题电池

24c04新电池

[ 本帖最后由 ps2004 于 2007-3-29 00:58 编辑 ]

ps2004 发表于 2007-3-30 10:41

我的这个电池并不是像有人说得那样,开盖也没锁。又用了BATTERYMON和DATTERYDoubler软件来了几次充放电确认是电心老化。32WH变成了8WH.虽有三橙一绿还是可以用20多分钟。

[ 本帖最后由 ps2004 于 2007-3-30 10:49 编辑 ]

ps2004 发表于 2007-3-30 10:47

充放电图

battermon

jy03k 发表于 2007-9-29 16:58

图片呢?

jingyunxz 发表于 2007-11-24 21:52

怎么解决的啊???图呢?忽悠
页: [1]
查看完整版本: 求高手帮忙DELL D600电池6Y270的问题bq8011(已解决。有图)