Memory module for g5

huzhi28251

本帖最后由 huzhi28251 于 2020-6-22 07:05 编辑

Memory module
The computer includes four memory module sockets. Two memory module sockets are accessible for authorized service providers.
该计算机包括四个内存模块插槽。授权服务提供商可以访问两个内存模块插槽。
Description
Spare part number
For use in models with Intel Core or Xeon processors
16GB
937438-850
8 GB
937236-850
4 GB
LI 0598-850
For use in models with Intel Xeon processors
16GB
L24981-001
8 GB
L24983-001
Update BIOS before adding memory modules
Before adding new memory, make sure you update the computer to the latest BIOS.
公 CAUTION: Failure to update the computer to the latest BIOS prior to installing new memory may result in various system problems.
To update BIOS:
1. Navigate to httD：〃www.hMorn/sLiuDQrt.
2. Follow the on-screen instructions to find your product.
3. Select Software and Drivers, and then select Go.
4. Expand BIOS.
5. SelectDownload, and then follow the on-screen instructions.
Before removing a memory module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer;
4. Remove the service door (see Service door on d冲 41 ).
5. Disconnect the battery (see Batt，rv on Dtqn 43).
6. Remove the hard drive (see Hard drive on Dvqe 45).
7. Remove the keyboard (see K-yboard on paqe 53).
8. Remove the bottom cover (see Bottom cover on uaqe 55).
9. Remove the system board (see System board on uaqe 66).
翻译成中文
##########################
在卸下内存模块之前，请执行以下步骤：
1.关闭计算机。如果不确定计算机是处于关闭状态还是休眠状态，请先打开计算机，然后通过操作系统将其关闭。
2.通过从计算机上拔下电源线来断开计算机的电源。
3.断开所有外部设备与计算机的连接；
4.卸下检修门E壳（请参阅d冲41上的检修门）。
5.断开电池连接（请参阅Batt，Dtqn 43上的rv）。
6.卸下硬盘驱动器（请参阅Dvqe 45上的硬盘驱动器）。
7.卸下键盘（请参阅第53页的K-yboard）。
8.卸下底盖D壳（请参阅uaqe 55上的底盖）。
9.卸下系统主板（请参阅uaqe 66上的系统板）。
##########################################

The computer includes four memory module sockets. Two memory module sockets are accessible for authorized service providers.
Remove the memory module:
1. Remove the DDR cage shielding.
72 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
2.
Spread the retaining tabs (1) on each side of the memory module slot to release the memory module. (The memory module tilts up.)
3.
Remove the memory module (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install a memory module.
冒 NOTE: Memory modules are notched to prevent incorrect installation.