|
发表于 2024-11-30 15:42:23| 字数 7,686| - 中国–广东–深圳 联通
|
显示全部楼层
本帖最后由 倍哥也是哥 于 2024-11-30 15:44 编辑
- minidebian:~# smartctl -x /dev/sda
- smartctl 7.3 2022-02-28 r5338 [i686-linux-6.1.0-26-686] (local build)
- Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org
- === START OF INFORMATION SECTION ===
- Device Model: HTC426060G9AT00
- Serial Number: EPJD99
- Firmware Version: 00P3A0L2
- User Capacity: 60,011,642,880 bytes [60.0 GB]
- Sector Size: 512 bytes logical/physical
- Device is: Not in smartctl database 7.3/5319
- ATA Version is: ATA/ATAPI-6 T13/1410D revision 3a
- Local Time is: Sat Nov 30 15:40:40 2024 CST
- SMART support is: Available - device has SMART capability.
- SMART support is: Enabled
- AAM feature is: Unavailable
- APM level is: 254 (maximum performance)
- Rd look-ahead is: Enabled
- Write cache is: Enabled
- DSN feature is: Unavailable
- ATA Security is: Disabled, frozen [SEC2]
- Wt Cache Reorder: Unavailable
- === START OF READ SMART DATA SECTION ===
- SMART overall-health self-assessment test result: PASSED
- General SMART Values:
- Offline data collection status: (0x00) Offline data collection activity
- was never started.
- Auto Offline Data Collection: Disabled.
- Self-test execution status: ( 18) The self-test routine was aborted by
- the host.
- Total time to complete Offline
- data collection: ( 3260) seconds.
- Offline data collection
- capabilities: (0x5b) SMART execute Offline immediate.
- Auto Offline data collection on/off support.
- Suspend Offline collection upon new
- command.
- Offline surface scan supported.
- Self-test supported.
- No Conveyance Self-test supported.
- Selective Self-test supported.
- SMART capabilities: (0x0003) Saves SMART data before entering
- power-saving mode.
- Supports SMART auto save timer.
- Error logging capability: (0x01) Error logging supported.
- No General Purpose Logging support.
- Short self-test routine
- recommended polling time: ( 2) minutes.
- Extended self-test routine
- recommended polling time: ( 55) minutes.
- SMART Attributes Data Structure revision number: 16
- Vendor Specific SMART Attributes with Thresholds:
- ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE
- 1 Raw_Read_Error_Rate P-SR-- 100 100 050 - 0
- 2 Throughput_Performance P-S--- 100 100 050 - 23450
- 3 Spin_Up_Time POS--- 100 100 050 - 0
- 4 Start_Stop_Count -O--CK 094 094 000 - 6759
- 5 Reallocated_Sector_Ct PO--CK 097 097 010 - 75
- 7 Seek_Error_Rate POSR-- 100 100 050 - 832
- 8 Seek_Time_Performance P-S--- 100 100 050 - 1254
- 9 Power_On_Hours -O--CK 001 001 000 - 4739330
- 10 Spin_Retry_Count PO--C- 100 100 050 - 0
- 12 Power_Cycle_Count -O--CK 094 094 000 - 6048
- 191 G-Sense_Error_Rate -O-R-- 100 079 000 - 4294967295
- 192 Power-Off_Retract_Count -O--CK 100 100 000 - 260
- 193 Load_Cycle_Count -O--CK 001 001 000 - 23282733886964
- 194 Temperature_Celsius -O---K 100 062 000 - 34 (Min/Max 1/57)
- 195 Hardware_ECC_Recovered -O-RC- 100 001 000 - 11327
- 196 Reallocated_Event_Count -O--CK 093 093 000 - 75
- 197 Current_Pending_Sector -O--CK 100 094 000 - 0
- 198 Offline_Uncorrectable ----C- 100 100 000 - 0
- 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0
- 200 Multi_Zone_Error_Rate PO--C- 100 100 050 - 0
- 201 Soft_Read_Error_Rate -O--C- 100 100 000 - 1
- 223 Load_Retry_Count -O--C- 100 100 000 - 0
- 230 Head_Amplitude -O--CK 010 010 000 - 2703829
- 250 Read_Error_Retry_Rate -O-R-- 100 001 000 - 899
- ||||||_ K auto-keep
- |||||__ C event count
- ||||___ R error rate
- |||____ S speed/performance
- ||_____ O updated online
- |______ P prefailure warning
- General Purpose Log Directory not supported
- SMART Log Directory Version 1 [multi-sector log support]
- Address Access R/W Size Description
- 0x00 SL R/O 1 Log Directory
- 0x01 SL R/O 1 Summary SMART error log
- 0x02 SL R/O 51 Comprehensive SMART error log
- 0x06 SL R/O 1 SMART self-test log
- 0x09 SL R/W 1 Selective self-test log
- 0x80-0x9f SL R/W 16 Host vendor specific log
- 0xa0 SL VS 1 Device vendor specific log
- 0xa1-0xa2 SL VS 96 Device vendor specific log
- 0xa3-0xbf SL VS 1 Device vendor specific log
- SMART Extended Comprehensive Error Log (GP Log 0x03) not supported
- SMART Error Log Version: 1
- Warning: ATA error count 65535 inconsistent with error log pointer 4
- ATA Error Count: 65535 (device log contains only the most recent five errors)
- CR = Command Register [HEX]
- FR = Features Register [HEX]
- SC = Sector Count Register [HEX]
- SN = Sector Number Register [HEX]
- CL = Cylinder Low Register [HEX]
- CH = Cylinder High Register [HEX]
- DH = Device/Head Register [HEX]
- DC = Device Command Register [HEX]
- ER = Error register [HEX]
- ST = Status register [HEX]
- Powered_Up_Time is measured from power on, and printed as
- DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
- SS=sec, and sss=millisec. It "wraps" after 49.710 days.
- Error 65535 occurred at disk power-on lifetime: 65535 hours (2730 days + 15 hours)
- When the command that caused the error occurred, the device was active or idle.
- After command completion occurred, registers were:
- ER ST SC SN CL CH DH
- -- -- -- -- -- -- --
- 40 51 01 ee 14 1c e2 Error: UNC 1 sectors at LBA = 0x021c14ee = 35394798
- Commands leading to the command that caused the error were:
- CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
- -- -- -- -- -- -- -- -- ---------------- --------------------
- c8 00 08 e7 14 1c e2 00 00:01:52.960 READ DMA
- ca 00 80 17 2e 02 e0 00 00:01:52.950 WRITE DMA
- ca 00 80 97 2d 02 e0 00 00:01:52.950 WRITE DMA
- ca 00 80 17 2d 02 e0 00 00:01:52.950 WRITE DMA
- ca 00 80 97 2c 02 e0 00 00:01:52.950 WRITE DMA
- Error 65534 occurred at disk power-on lifetime: 65535 hours (2730 days + 15 hours)
- When the command that caused the error occurred, the device was active or idle.
- After command completion occurred, registers were:
- ER ST SC SN CL CH DH
- -- -- -- -- -- -- --
- 40 51 39 ee 14 1c e2 Error: UNC 57 sectors at LBA = 0x021c14ee = 35394798
- Commands leading to the command that caused the error were:
- CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
- -- -- -- -- -- -- -- -- ---------------- --------------------
- c8 00 40 e7 14 1c e2 00 00:01:50.440 READ DMA
- e7 00 00 00 00 00 a0 00 00:01:50.430 FLUSH CACHE
- e7 00 00 00 00 00 a0 00 00:01:50.410 FLUSH CACHE
- ca 00 08 df 00 00 e0 00 00:01:50.410 WRITE DMA
- ca 00 08 5f 49 3c e0 00 00:01:50.410 WRITE DMA
- Error 65533 occurred at disk power-on lifetime: 65535 hours (2730 days + 15 hours)
- When the command that caused the error occurred, the device was active or idle.
- After command completion occurred, registers were:
- ER ST SC SN CL CH DH
- -- -- -- -- -- -- --
- 40 51 01 ee 14 1c e2 Error: UNC 1 sectors at LBA = 0x021c14ee = 35394798
- Commands leading to the command that caused the error were:
- CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
- -- -- -- -- -- -- -- -- ---------------- --------------------
- c8 00 08 e7 14 1c e2 00 00:02:21.140 READ DMA
- ca 00 38 7f bf 00 e0 00 00:02:21.140 WRITE DMA
- ca 00 28 cf 70 60 e0 00 00:02:21.130 WRITE DMA
- c8 00 40 e7 14 1c e2 00 00:02:18.700 READ DMA
- ca 00 08 77 bf 00 e0 00 00:02:18.690 WRITE DMA
- Error 65532 occurred at disk power-on lifetime: 65535 hours (2730 days + 15 hours)
- When the command that caused the error occurred, the device was active or idle.
- After command completion occurred, registers were:
- ER ST SC SN CL CH DH
- -- -- -- -- -- -- --
- 40 51 39 ee 14 1c e2 Error: UNC 57 sectors at LBA = 0x021c14ee = 35394798
- Commands leading to the command that caused the error were:
- CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
- -- -- -- -- -- -- -- -- ---------------- --------------------
- c8 00 40 e7 14 1c e2 00 00:02:18.700 READ DMA
- ca 00 08 77 bf 00 e0 00 00:02:18.690 WRITE DMA
- ca 00 08 6f bf 00 e0 00 00:02:18.690 WRITE DMA
- ca 00 48 27 bf 00 e0 00 00:02:18.690 WRITE DMA
- ca 00 08 d7 00 00 e0 00 00:02:18.680 WRITE DMA
- Error 65531 occurred at disk power-on lifetime: 65535 hours (2730 days + 15 hours)
- When the command that caused the error occurred, the device was active or idle.
- After command completion occurred, registers were:
- ER ST SC SN CL CH DH
- -- -- -- -- -- -- --
- 40 51 01 ee 14 1c e2 Error: UNC 1 sectors at LBA = 0x021c14ee = 35394798
- Commands leading to the command that caused the error were:
- CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
- -- -- -- -- -- -- -- -- ---------------- --------------------
- c8 00 08 e7 14 1c e2 00 00:02:02.010 READ DMA
- ca 00 08 27 45 60 e0 00 00:02:02.010 WRITE DMA
- c8 00 40 e7 14 1c e2 00 00:01:59.470 READ DMA
- ca 00 18 f7 44 60 e0 00 00:01:59.470 WRITE DMA
- ca 00 10 df 44 60 e0 00 00:01:59.460 WRITE DMA
- SMART Extended Self-test Log (GP Log 0x07) not supported
- SMART Self-test log structure revision number 1
- Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
- # 1 Extended offline Aborted by host 20% 12826 -
- # 2 Short offline Aborted by host 10% 16270 -
- SMART Selective self-test log data structure revision number 1
- SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
- 1 0 0 Not_testing
- 2 0 0 Not_testing
- 3 0 0 Not_testing
- 4 0 0 Not_testing
- 5 0 0 Not_testing
- Selective self-test flags (0x0):
- After scanning selected spans, do NOT read-scan remainder of disk.
- If Selective self-test is pending on power-up, resume after 0 minute delay.
- SCT Commands not supported
- Device Statistics (GP/SMART Log 0x04) not supported
- Pending Defects log (GP Log 0x0c) not supported
- SATA Phy Event Counters (GP Log 0x11) not supported
- minidebian:~#
复制代码
9 Power_On_Hours -O--CK 001 001 000 - 4739330
这不一定准确,但的确吓人一跳。
|
|